RFC5224: Diameter Policy Processing Application
Download in PDF format Download in text format
Related keywords:
(oma)
(open mobile alliance)
(or evaluation and enforcement)
(peem)
(pem-1)
(policy evaluation)
Network Working Group M. Brenner Request for Comments: 5224 Alcatel-Lucent Category: Informational March 2008 Diameter Policy Processing Application Status of This Memo This memo provides information for the Internet community. It does not specify an Internet standard of any kind. Distribution of this memo is unlimited. Abstract This document describes the need for a new IANA Diameter Command Code to be used in a vendor-specific new application for invocation of Policy Processing (Policy Evaluation, or Evaluation and Enforcement). This application is needed as one of the implementations of the Open Mobile Alliance (OMA) Policy Evaluation, Enforcement and Management (PEEM) enabler, namely for the PEM-1 interface used to send a request/response for Policy Processing. Table of Contents 1. Introduction . . . . . . . . . . . . . . . . . . . . . . . . . 2 2. Terminology . . . . . . . . . . . . . . . . . . . . . . . . . . 2 3. Diameter Policy Processing Application . . . . . . . . . . . . 2 4. Security Considerations . . . . . . . . . . . . . . . . . . . . 2 5. IANA Considerations . . . . . . . . . . . . . . . . . . . . . . 3 5.1. Command Codes . . . . . . . . . . . . . . . . . . . . . . . 3 5.2. AVP Codes . . . . . . . . . . . . . . . . . . . . . . . . . 3 5.3. Application Identifier . . . . . . . . . . . . . . . . . . 3 6. Acknowledgements . . . . . . . . . . . . . . . . . . . . . . . 3 7. References . . . . . . . . . . . . . . . . . . . . . . . . . . 4 7.1. Normative References . . . . . . . . . . . . . . . . . . . 4 7.2. Informative References . . . . . . . . . . . . . . . . . . 4 Brenner Informational [Page 1] RFC 5224 PEEM March 2008 1. Introduction This document summarizes the use of Diameter codes in a newly defined realization of a specification for invocation of policy processing. A new Command Code has been assigned by IANA. The document summarizes the uses of newly defined Diameter codes (a Command Code, an AVP, and a vendor-specific application id). When combined with the Diameter Base protocol, this application's specification satisfies the Open Mobile Alliance (OMA) Policy Evaluation, Enforcement, and Management (PEEM) requirements for sending a request for policy processing and receiving a response with the policy processing result. See [PEM-1-TS] for the normative use of Diameter. PEEM requirements are documented in [PEEM-RD] and PEEM Architecture is documented in [PEEM-AD]. The Diameter realization of this application assumes the use of the Diameter Base protocol, as per RFC 3588, and extends it only for a specific application using a vendor-id (PEN), a vendor-specific application ID, a new Command Code (314), and a new AVP defined in the vendor-specific namespace. Input to policy processing are being passed through a new AVP, and policy results are being passed through a combination of the same new AVP, and the Experimental-Result AVP. 2. Terminology The base Diameter specification (Section 1.4 of [RFC3588]) defines most of the terminology used in this document. Additionally, the terms and acronyms defined in [PEM-1-TS] are used in this document. 3. Diameter Policy Processing Application A detailed description of the Diameter Policy Processing Application can be found in Section 5.4.1 of the Policy Evaluation, Enforcement and Management Callable Interface (PEM-1) Technical Specification [PEM-1-TS]. 4. Security Considerations This document describes the Diameter Policy Processing Application. It builds on top of the Diameter Base protocol and the same security considerations described in RFC 3588 [RFC3588] are applicable to this document. No further extensions are required beyond the security mechanisms offered by RFC 3588. Brenner Informational [Page 2] RFC 5224 PEEM March 2008 5. IANA Considerations This section provides guidance to the Internet Assigned Numbers Authority (IANA) regarding registration of values related to the Diameter protocol, in accordance with BCP 26 [RFC2434]. This document defines values in the namespaces that have been created and defined in the Diameter Base [RFC3588]. The IANA Considerations section of that document details the assignment criteria. Values assigned in this document, or by future IANA action, must be coordinated within this shared namespace. 5.1. Command Codes This specification assigns the value 314 from the Command Code namespace defined in [RFC3588]. See Section 5.4.1.3.1 of [PEM-1-TS] to see how the command code is used. IANA has made the following assignment in the "Authentication, Authorization, and Accounting (AAA) Parameters" registry, in the sub- registry "Command Codes". Code Value Name Reference -------------- ------------------------------- --------- 314 PDR / PDA [RFC5224] 5.2. AVP Codes This specification uses the value 1 for the Policy-Data AVP, in the OMA Vendor-ID (PEN) AVP namespace. See Section 5.4.1.3.3 of [PEM-1-TS] for the assignment of the namespace in this specification. 5.3. Application Identifier This specification uses the value 16777243 in the Application Identifier namespace as registered in IANA for the Policy Processing Application. See Section 5.4.1.3 of [PEM-1-TS] for more information. 6. Acknowledgements The author would like to thank Dan Romascanu and Hannes Tschofenig for their help and support. Finally, the author would like to thank Alcatel-Lucent, as most of the effort put into this document was done while he was in their employ. Brenner Informational [Page 3] RFC 5224 PEEM March 2008 7. References 7.1. Normative References [PEM-1-TS] Open Mobile Alliance, "Policy Evaluation, Enforcement and Management Callable Interface (PEM-1) Technical Specification, Draft Version 1.0, available at http:// www.openmobilealliance.org/ftp/Public_documents/ARCH/ Permanent_documents/ OMA-TS-PEEM_PEM1-V1_0-20080325-D.zip", December 2007. [RFC3588] Calhoun, P., Loughney, J., Guttman, E., Zorn, G., and J. Arkko, "Diameter Base Protocol", RFC 3588, September 2003. 7.2. Informative References [PEEM-AD] Open Mobile Alliance, "Policy Evaluation, Enforcement and Management Architecture, Draft Version 1.0, available at http://www.openmobilealliance.org/ftp/Public_documents/ ARCH/Permanent_documents/ OMA-AD-Policy_Evaluation_Enforcement_Management-V1_0_0- 20060625-D.zip", June 2006. [PEEM-RD] Open Mobile Alliance, "Policy Evaluation, Enforcement and Management Requirements, Candidate Version 1.0, 12 January 2005, available at http:// www.openmobilealliance.org/ftp/Public_documents/ARCH/ permanent_documents/ OMA-RD-Policy_Evaluation_Enforcement_Management-V1_0- 20050112-C.zip", November 2005. [RFC2434] Narten, T. and H. Alvestrand, "Guidelines for Writing an IANA Considerations Section in RFCs", BCP 26, RFC 2434, October 1998. Author's Address Michael Brenner Alcatel-Lucent 600-700 Mountain Avenue, 2D-148 Murray Hill, NJ 07974-0636 USA Phone: +1 908-582-8753 EMail: mrbrenner@alcatel-lucent.com Brenner Informational [Page 4] RFC 5224 PEEM March 2008 Full Copyright Statement Copyright (C) The IETF Trust (2008). This document is subject to the rights, licenses and restrictions contained in BCP 78, and except as set forth therein, the authors retain all their rights. This document and the information contained herein are provided on an "AS IS" basis and THE CONTRIBUTOR, THE ORGANIZATION HE/SHE REPRESENTS OR IS SPONSORED BY (IF ANY), THE INTERNET SOCIETY, THE IETF TRUST AND THE INTERNET ENGINEERING TASK FORCE DISCLAIM ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF THE INFORMATION HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. Intellectual Property The IETF takes no position regarding the validity or scope of any Intellectual Property Rights or other rights that might be claimed to pertain to the implementation or use of the technology described in this document or the extent to which any license under such rights might or might not be available; nor does it represent that it has made any independent effort to identify any such rights. Information on the procedures with respect to rights in RFC documents can be found in BCP 78 and BCP 79. Copies of IPR disclosures made to the IETF Secretariat and any assurances of licenses to be made available, or the result of an attempt made to obtain a general license or permission for the use of such proprietary rights by implementers or users of this specification can be obtained from the IETF on-line IPR repository at http://www.ietf.org/ipr. The IETF invites any interested party to bring to its attention any copyrights, patents or patent applications, or other proprietary rights that may cover technology that may be required to implement this standard. Please address the information to the IETF at ietf-ipr@ietf.org. Brenner Informational [Page 5]