RFC6166: A Registry for PIM Message Types
Download in PDF format Download in text format
Obsoleted By:
RFC8736
Related keywords:
(IANA)
(Protocol Independent Multicast)
Internet Engineering Task Force (IETF) S. Venaas Request for Comments: 6166 Cisco Systems Category: Standards Track April 2011 ISSN: 2070-1721 A Registry for PIM Message Types Abstract This document provides instructions to IANA for the creation of a registry for PIM message types. It specifies the initial content of the registry, based on existing RFCs specifying PIM message types. It also specifies a procedure for registering new types. In addition to this, one message type is reserved, and may be used for a future extension of the message type space. Status of This Memo This is an Internet Standards Track document. This document is a product of the Internet Engineering Task Force (IETF). It represents the consensus of the IETF community. It has received public review and has been approved for publication by the Internet Engineering Steering Group (IESG). Further information on Internet Standards is available in Section 2 of RFC 5741. Information about the current status of this document, any errata, and how to provide feedback on it may be obtained at http://www.rfc-editor.org/info/rfc6166. Copyright Notice Copyright (c) 2011 IETF Trust and the persons identified as the document authors. All rights reserved. This document is subject to BCP 78 and the IETF Trust's Legal Provisions Relating to IETF Documents (http://trustee.ietf.org/license-info) in effect on the date of publication of this document. Please review these documents carefully, as they describe your rights and restrictions with respect to this document. Code Components extracted from this document must include Simplified BSD License text as described in Section 4.e of the Trust Legal Provisions and are provided without warranty as described in the Simplified BSD License. Venaas Standards Track [Page 1] RFC 6166 A Registry for PIM Message Types April 2011 Table of Contents 1. Introduction ....................................................2 2. Security Considerations .........................................2 3. IANA Considerations .............................................2 3.1. Initial Registry ...........................................3 3.2. Assignment of New Message Types ............................3 4. Acknowledgements ................................................3 5. Informative References ..........................................3 1. Introduction Apart from this document, there is no existing document specifying a registry for PIM message types. PIM version 1 made use of IGMP [RFC1112], and there is an IGMP registry [IGMPREG] listing the message types used by PIM version 1. PIM version 2, however, is not based on IGMP, and a separate PIM message type registry is needed. There are currently several RFCs specifying new PIM version 2 message types that should be in this new registry. They are the RFCs for PIM Dense Mode [RFC3973], PIM Sparse Mode [RFC4601], and Bidirectional PIM [RFC5015]. This document specifies the initial content of the new PIM message type registry, based on those existing RFCs. This document also specifies a procedure for registering new PIM message types. In addition to this, this document reserves one message type. This type may be used for a future extension of the message type space. The current message type space is only 4 bits, so it is not unlikely that this will be needed. How exactly the extension should be done is left to a future document. 2. Security Considerations This document only creates an IANA registry. There may be a security benefit in a well-known place for finding information on which PIM message types are valid and how they are used. Apart from that, there are no security considerations. 3. IANA Considerations IANA has created a PIM message type registry. It has been placed in the "Protocol Independent Multicast (PIM)" branch of the tree. Each entry in the registry consists of a message type, a message name, and references to the documents defining the type. The message type is a 4-bit integer with possible values from 0 to 15. Venaas Standards Track [Page 2] RFC 6166 A Registry for PIM Message Types April 2011 3.1. Initial Registry The initial content of the registry should be as follows. Type Name Reference ------ ---------------------------------------- ------------------- 0 Hello [RFC3973] [RFC4601] 1 Register [RFC4601] 2 Register Stop [RFC4601] 3 Join/Prune [RFC3973] [RFC4601] 4 Bootstrap [RFC4601] 5 Assert [RFC3973] [RFC4601] 6 Graft [RFC3973] 7 Graft-Ack [RFC3973] 8 Candidate RP Advertisement [RFC4601] 9 State Refresh [RFC3973] 10 DF Election [RFC5015] 11-14 Unassigned 15 Reserved (for extension of type space) this document 3.2. Assignment of New Message Types Assignment of new message types is done according to the "IETF Review" model; see [RFC5226]. 4. Acknowledgements Thanks to Toerless Eckert for his suggestion to reserve a type for future extension of the message type space. Also thanks to Mykyta Yevstifeyev for reviewing the document and proposing improvements to the text. 5. Informative References [IGMPREG] IANA, "Internet Group Management Protocol (IGMP) Type Numbers - per [RFC3228], [BCP57]", <http://www.iana.org/>. [RFC1112] Deering, S., "Host extensions for IP multicasting", STD 5, RFC 1112, August 1989. [RFC3973] Adams, A., Nicholas, J., and W. Siadak, "Protocol Independent Multicast - Dense Mode (PIM-DM): Protocol Specification (Revised)", RFC 3973, January 2005. [RFC4601] Fenner, B., Handley, M., Holbrook, H., and I. Kouvelas, "Protocol Independent Multicast - Sparse Mode (PIM-SM): Protocol Specification (Revised)", RFC 4601, August 2006. Venaas Standards Track [Page 3] RFC 6166 A Registry for PIM Message Types April 2011 [RFC5015] Handley, M., Kouvelas, I., Speakman, T., and L. Vicisano, "Bidirectional Protocol Independent Multicast (BIDIR- PIM)", RFC 5015, October 2007. [RFC5226] Narten, T. and H. Alvestrand, "Guidelines for Writing an IANA Considerations Section in RFCs", BCP 26, RFC 5226, May 2008. Author's Address Stig Venaas Cisco Systems Tasman Drive San Jose, CA 95134 USA EMail: stig@cisco.com Venaas Standards Track [Page 4]