RFC9214: OSPFv3 Code Point for MPLS LSP Ping
Download in text format
Related keywords:
(mpls)
Internet Engineering Task Force (IETF) N. Nainar
Request for Comments: 9214 C. Pignataro
Updates: 8287 Cisco Systems, Inc.
Category: Standards Track M. Aissaoui
ISSN: 2070-1721 Nokia
April 2022
OSPFv3 Code Point for MPLS LSP Ping
Abstract
IANA has created "Protocol in the Segment ID Sub-TLV" and "Protocol
in Label Stack Sub-TLV of Downstream Detailed Mapping TLV" registries
under the "Multiprotocol Label Switching (MPLS) Label Switched Paths
(LSPs) Ping Parameters" registry. RFC 8287 defines the code points
for Open Shortest Path First (OSPF) and Intermediate System to
Intermediate System (IS-IS) protocols.
This document specifies the code point to be used in the Segment ID
sub-TLV and Downstream Detailed Mapping (DDMAP) TLV when the Interior
Gateway Protocol (IGP) is OSPFv3. This document also updates
RFC 8287 by clarifying that the existing "OSPF" code point is to be
used only to indicate OSPFv2 and by defining the behavior when the
Segment ID sub-TLV indicates the use of IPv6.
Status of This Memo
This is an Internet Standards Track document.
This document is a product of the Internet Engineering Task Force
(IETF). It represents the consensus of the IETF community. It has
received public review and has been approved for publication by the
Internet Engineering Steering Group (IESG). Further information on
Internet Standards is available in Section 2 of RFC 7841.
Information about the current status of this document, any errata,
and how to provide feedback on it may be obtained at
https://www.rfc-editor.org/info/rfc9214.
Copyright Notice
Copyright (c) 2022 IETF Trust and the persons identified as the
document authors. All rights reserved.
This document is subject to BCP 78 and the IETF Trust's Legal
Provisions Relating to IETF Documents
(https://trustee.ietf.org/license-info) in effect on the date of
publication of this document. Please review these documents
carefully, as they describe your rights and restrictions with respect
to this document. Code Components extracted from this document must
include Revised BSD License text as described in Section 4.e of the
Trust Legal Provisions and are provided without warranty as described
in the Revised BSD License.
Table of Contents
1. Introduction
2. Requirements Notation
3. Terminology
4. OSPFv3 Protocol in Segment ID Sub-TLVs
5. OSPFv3 Protocol in Downstream Detailed Mapping TLV
6. Update to RFC 8287 - OSPFv2 Protocol in Segment ID and DDMAP
Sub-TLVs
7. IANA Considerations
7.1. Protocol in the Segment ID Sub-TLV
7.2. Protocol in Label Stack Sub-TLV of Downstream Detailed
Mapping TLV
8. Security Considerations
9. Normative References
Acknowledgements
Authors' Addresses
1. Introduction
IANA has created the "Protocol in the Segment ID Sub-TLV" registry
and "Protocol in Label Stack Sub-TLV of Downstream Detailed Mapping
TLV" registries under the "Multiprotocol Label Switching (MPLS) Label
Switched Paths (LSPs) Ping Parameters" registry [IANA-MPLS-LSP-PING].
[RFC8287] defines the code points for OSPF and IS-IS.
"OSPF for IPv6" [RFC5340] describes OSPF version 3 (OSPFv3) to
support IPv6. "Support of Address Families in OSPFv3" [RFC5838]
describes the mechanism to support multiple address families (AFs) in
OSPFv3. Accordingly, OSPFv3 may be used to advertise IPv6 and IPv4
prefixes.
This document specifies the code point to be used in the Segment ID
sub-TLV (Types 34, 35, and 36) and in the Downstream Detailed Mapping
(DDMAP) TLV when the IGP is OSPFv3.
This document also updates "Label Switched Path (LSP) Ping/Traceroute
for Segment Routing (SR) IGP-Prefix and IGP-Adjacency Segment
Identifiers (SIDs) with MPLS Data Planes" [RFC8287] by clarifying
that the existing "OSPF" code point is to be used only to indicate
OSPFv2 and by defining the behavior when the Segment ID sub-TLV
indicates the use of IPv6.
2. Requirements Notation
The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT",
"SHOULD", "SHOULD NOT", "RECOMMENDED", "NOT RECOMMENDED", "MAY", and
"OPTIONAL" in this document are to be interpreted as described in
BCP 14 [RFC2119] [RFC8174] when, and only when, they appear in all
capitals, as shown here.
3. Terminology
This document uses the terminology defined in "Segment Routing
Architecture" [RFC8402], "Detecting Multiprotocol Label Switched
(MPLS) Data-Plane Failures" [RFC8029], and "Label Switched Path (LSP)
Ping/Traceroute for Segment Routing (SR) IGP-Prefix and IGP-Adjacency
Segment Identifiers (SIDs) with MPLS Data Planes" [RFC8287], and so
the readers are expected to be familiar with the same.
4. OSPFv3 Protocol in Segment ID Sub-TLVs
When the protocol field of the Segment ID sub-TLV of Type 34 (IPv4
IGP-Prefix Segment ID), Type 35 (IPv6 IGP-Prefix Segment ID), and
Type 36 (IGP-Adjacency Segment ID) is set to 3, the responder MUST
perform the Forwarding Equivalence Class (FEC) validation using
OSPFv3 as the IGP.
The initiator MUST NOT set the protocol field of the Segment ID sub-
TLV Type 35 and Type 36 as OSPF (value 1) as OSPFv2 is not compatible
with the use of IPv6 addresses indicated by this sub-TLV.
When the protocol field in the received Segment ID sub-TLV Type 35
and Type 36 is OSPF (value 1), the responder MAY treat the protocol
value as "Any IGP Protocol" (value 0) according to step 4a of
Section 7.4 of [RFC8287]. This allows the responder to support
legacy implementations that use value 1 to indicate OSPFv3.
5. OSPFv3 Protocol in Downstream Detailed Mapping TLV
The protocol field of the DDMAP TLV in an echo reply is set to 7 when
OSPFv3 is used to distribute the label carried in the Downstream
Label field.
6. Update to RFC 8287 - OSPFv2 Protocol in Segment ID and DDMAP Sub-
TLVs
Section 5 of [RFC8287] defines the code point for OSPF to be used in
the Protocol field of the Segment ID sub-TLV. Section 6 of [RFC8287]
defines the code point for OSPF to be used in the Protocol field of
the DDMAP TLV.
This document updates [RFC8287] by specifying that the "OSPF" code
points SHOULD be used only for OSPFv2.
7. IANA Considerations
7.1. Protocol in the Segment ID Sub-TLV
IANA has assigned a new code point from the "Protocol in the Segment
ID Sub-TLV" registry under the "Multiprotocol Label Switching (MPLS)
Label Switched Paths (LSPs) Ping Parameters" registry as follows:
+=======+=========+===========+
| Value | Meaning | Reference |
+=======+=========+===========+
| 3 | OSPFv3 | RFC 9214 |
+-------+---------+-----------+
Table 1
IANA has added a note for the existing entry for code point 1 (OSPF):
"To be used for OSPFv2 only".
7.2. Protocol in Label Stack Sub-TLV of Downstream Detailed Mapping TLV
IANA has assigned a new code point for OSPFv3 from "Protocol in Label
Stack Sub-TLV of Downstream Detailed Mapping TLV" registry under the
"Multiprotocol Label Switching (MPLS) Label Switched Paths (LSPs)
Ping Parameters" registry as follows:
+=======+=========+===========+
| Value | Meaning | Reference |
+=======+=========+===========+
| 7 | OSPFv3 | RFC 9214 |
+-------+---------+-----------+
Table 2
IANA has added a note for the existing codepoint 5 (OSPF): "To be
used for OSPFv2 only".
8. Security Considerations
This document updates [RFC8287] and does not introduce any additional
security considerations. See [RFC8029] to see generic security
considerations about the MPLS LSP Ping.
9. Normative References
[IANA-MPLS-LSP-PING]
IANA, "Multiprotocol Label Switching (MPLS) Label Switched
Paths (LSPs) Ping Parameters",
<https://www.iana.org/assignments/mpls-lsp-ping-
parameters>.
[RFC2119] Bradner, S., "Key words for use in RFCs to Indicate
Requirement Levels", BCP 14, RFC 2119,
DOI 10.17487/RFC2119, March 1997,
<https://www.rfc-editor.org/info/rfc2119>.
[RFC5340] Coltun, R., Ferguson, D., Moy, J., and A. Lindem, "OSPF
for IPv6", RFC 5340, DOI 10.17487/RFC5340, July 2008,
<https://www.rfc-editor.org/info/rfc5340>.
[RFC5838] Lindem, A., Ed., Mirtorabi, S., Roy, A., Barnes, M., and
R. Aggarwal, "Support of Address Families in OSPFv3",
RFC 5838, DOI 10.17487/RFC5838, April 2010,
<https://www.rfc-editor.org/info/rfc5838>.
[RFC8029] Kompella, K., Swallow, G., Pignataro, C., Ed., Kumar, N.,
Aldrin, S., and M. Chen, "Detecting Multiprotocol Label
Switched (MPLS) Data-Plane Failures", RFC 8029,
DOI 10.17487/RFC8029, March 2017,
<https://www.rfc-editor.org/info/rfc8029>.
[RFC8174] Leiba, B., "Ambiguity of Uppercase vs Lowercase in RFC
2119 Key Words", BCP 14, RFC 8174, DOI 10.17487/RFC8174,
May 2017, <https://www.rfc-editor.org/info/rfc8174>.
[RFC8287] Kumar, N., Ed., Pignataro, C., Ed., Swallow, G., Akiya,
N., Kini, S., and M. Chen, "Label Switched Path (LSP)
Ping/Traceroute for Segment Routing (SR) IGP-Prefix and
IGP-Adjacency Segment Identifiers (SIDs) with MPLS Data
Planes", RFC 8287, DOI 10.17487/RFC8287, December 2017,
<https://www.rfc-editor.org/info/rfc8287>.
[RFC8402] Filsfils, C., Ed., Previdi, S., Ed., Ginsberg, L.,
Decraene, B., Litkowski, S., and R. Shakir, "Segment
Routing Architecture", RFC 8402, DOI 10.17487/RFC8402,
July 2018, <https://www.rfc-editor.org/info/rfc8402>.
Acknowledgements
The authors would like to thank Les Ginsberg, Zafar Ali, Loa
Andersson, Andrew Molotchko, Deborah Brungard, Acee Lindem, and
Adrian Farrel for their review and suggestions.
The authors also would like to thank Christer Holmberg, Tero Kivinen,
Matthew Bocci, Tom Petch, and Martin Vigoureux for their review
comments.
Authors' Addresses
Nagendra Kumar Nainar
Cisco Systems, Inc.
7200-12 Kit Creek Road
Research Triangle Park, NC 27709
United States of America
Email: naikumar@cisco.com
Carlos Pignataro
Cisco Systems, Inc.
7200-11 Kit Creek Road
Research Triangle Park, NC 27709
United States of America
Email: cpignata@cisco.com
Mustapha Aissaoui
Nokia
Canada
Email: mustapha.aissaoui@nokia.com